Kawasaki Brute Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
I blew a belt yesterday and replaced it today and now it runs but it acts like the override isnt working. It's like when in reverse hitting the limiter going either direction all the time. Now with that being said. The button for the override does not seem to work. So would the switch not working cause it to act this way? And the first red light on the dash is blinking red steady Please and thank you for your help!!!
 

·
Super Moderator
Joined
·
13,443 Posts
Blowing the belt trips the belt switch in the cover. After replacing the belt you first have to re-set that switch to the ON position. After installing the cover you will have to go through the belt reset procedure as outlined in your owners or service manual. Otherwise it will stay in "LIMP" mode ...forever.
 
1 - 2 of 2 Posts
Top