I jus installed a snorkel kit on my brute force 750 and it idles high. Does anyone know what could be wrong?
__________________ SAVOIE 06Brute Force 750i 4x4 full snorkle K&N filter moose power module black HMF exhaust high performance belt 2'' lift 29.5'' Outlaws SS rims DynoJet jet kit
I jus installed a snorkel kit on my brute force 750 and it idles high. Does anyone know what could be wrong?
Hi 750MUDDER, welcome to the site. Snorkeling tends to cause a carbed Brute to need jetted down, but not at idle. I would suggest taking a look to make sure the throttle and choke cables and the snorkel are not at odd and pulling on each other.
Its an 06 and the idle screw does nothing when i mess with it.
__________________ SAVOIE 06Brute Force 750i 4x4 full snorkle K&N filter moose power module black HMF exhaust high performance belt 2'' lift 29.5'' Outlaws SS rims DynoJet jet kit
Its an 06 and the idle screw does nothing when i mess with it.
Oh...up or down? Once when I had my carbs off I rotated them when I put them back on and it put a twist in the cables that pulled on the throttle enough to open the butterflyes and hold the idle stop off the screw. So, that why I say maybe something is pulling on the cable. It does run through that area where most put snorkles.
No matter which way i turn it nothing happens. It ran fine before so i'll check the cables like u said.
__________________ SAVOIE 06Brute Force 750i 4x4 full snorkle K&N filter moose power module black HMF exhaust high performance belt 2'' lift 29.5'' Outlaws SS rims DynoJet jet kit
I bet NMKAWIERIDER is right. You have something that's got the cables in a bind and pulling the trottle open just a hair. This happened to me a while back except it was more than idled high. I didn't know what was going on till I found the problem.
__________________
Go Big or stay Home!
05 750 Brute Force, Frt. and Rear baskets, Gun Scabard, 08 dry box upgrade, K&N air filter, VX-3000 Viper winch, pass. pad, 27" swamplites all around, ss108 wheels, skid pkg and frt bumper, Dynatek CDI and Maroon Primary clutch spring, HighLifter HD Springs on the rear from SS ATV along with their stainless custom floor board protectors, HD tie rod ends and HD stainless tie rods from ATV Trick Stuff, Mudlid breather from EHS racing, TwinAir Powerflow Kit and More to come!!!
__________________ SAVOIE 06Brute Force 750i 4x4 full snorkle K&N filter moose power module black HMF exhaust high performance belt 2'' lift 29.5'' Outlaws SS rims DynoJet jet kit
One of my best friends here at the plant where I work has the last name of SAVOIE. He is also on my HHS DMAT team and been through the shiz with me. Was side by side with me during my 9 days in the superdome at Katrina, and more. You kin?
__________________
Go Big or stay Home!
05 750 Brute Force, Frt. and Rear baskets, Gun Scabard, 08 dry box upgrade, K&N air filter, VX-3000 Viper winch, pass. pad, 27" swamplites all around, ss108 wheels, skid pkg and frt bumper, Dynatek CDI and Maroon Primary clutch spring, HighLifter HD Springs on the rear from SS ATV along with their stainless custom floor board protectors, HD tie rod ends and HD stainless tie rods from ATV Trick Stuff, Mudlid breather from EHS racing, TwinAir Powerflow Kit and More to come!!!
high idle?
Linear Mode
